B&D CAD P Diamond Manual

Coding Transmitters

Setting the Transmitter to Operate Vacation Mode

The opener can be programmed into a “Vacation Mode” where the opener will not respond to any transmitter except one preprogrammed unit.

a. Press CODE SET button three times. The CODE SET LED will illuminate and the courtesy light will flash slowly (once every two seconds) to indicate Vacation learning mode is active. (Fig. 32)

b. Choose a transmitter button not already coded into the receiver. Press this button and the CODE SET LED will begin to fl ash.

c. Press the same transmitter button again. The CODE SET LED will illuminate for one second and then go out, and the courtesy light will also switch off. This indicates the code has been stored (Fig. 32).

d. To activate Vacation Mode, close the garage door and press the coded button transmitter for 5 seconds. The CODE SET LED will illuminate to indicate that the opener is in Vacation Mode.

e. To exit Vacation Mode press the transmitter button momentarily until the CODE SET LED turns off.

Setting the Transmitter to Operate the Auxiliary Output

It is possible to operate other devices (e.g. alarm systems) using one of the spare buttons of a multi-channel transmitter coded into the Auxiliary Output feature.

a. Press CODE SET button four times. The CODE SET LED will illuminate and the courtesy light will flash quickly (twice per second) to indicate that learning mode for the Auxiliary Output is active.
b. Choose a transmitter button not already coded into the receiver. Press this button and the CODE SET LED will begin to fl ash.
c. Press the same transmitter button again. The CODE SET LED will illuminate for one second and then go out, and the courtesy light will also switch off. This indicates the code has been stored (Fig. 33).