ATA KPX-6 Wireless Keypad Coding Instruction

Storing your PIN number

Note: There is a timeout of approximately 5 seconds after the last button is pressed.

a. Enter 1111 followed by the hash (#) key.

b. Press and hold the hash (#) key again. The keypad will beep for approximately 5 seconds. Once the beeping stops, release the hash (#) key. Enter the new pin code followed by the hash (#) key. Re-enter the new pin code followed by the hash (#) key to confirm. A short string of beeps will be produced to confirm the acceptance of the new pin code.

c. Test operation using the new code. Enter the new code followed by the hash (#) key. Press and hold any button from 1-8 and you should hear a continuous string of beeps.

Note: If you lose or forget a code, you will need to return the Keypad to Automatic Technology for reprogramming. A charge will apply for this service.

Coding the Keypad into the Opener

a. Press and hold the Door Code button on the control panel of your Automatic Technology TrioCode® garage door opener or SW1/SW2 on the TrioCode® receiver board.

b. Enter your pin code on the Keypad of the KPX-6 followed by the hash (#) key then press one of the eight (channel) buttons you wish to use to operate the door or gate etc.

c. Pause for a second and press the same button again on the Keypad of the KPX-6.

d. Release the Door Code or SW button. The Keypad code should now be stored into the opener’s memory.

e. Test the operation of the Keypad by entering your pin code followed by the hash (#) key and the stored channel button (1-8). The door or gate should start to move.