ATA GDO 11v2 User Manual Mono v100

Important Safety Instructions

The unit should be installed so that it is protected from the elements. It should not be exposed to water or rain. It is not to be immersed in water or sprayed directly by a hose or other device.

The garage door must be well balanced. Sticking or binding doors must be repaired by a qualifi ed garage door installer prior to installation of the opener.

Frequently examine the installation, in particular cables, springs and mountings for signs of wear, damage or imbalance. DO NOT use if repair or adjustment is needed since a fault in the installation or an incorrectly balanced door may cause injury. DO NOT attempt to repair the door yourself as hardware is under extreme tension.

Remove or disengage all garage door locks and mechanisms prior to installation of the opener.

Connect the opener to a properly earthed general purpose 240V mains power outlet installed by a qualifi ed electrical contractor.

Disconnect the power cord from mains power before making any repairs or removing covers. Only experienced service personnel should remove covers from the opener.

In order for the Ero™ to sense an object obstructing the door way, some force must be exerted on the object. As a result the object, door and/or person may suffer damage or injury.

If the power supply cord is damaged, it must be replaced by an Automatic Technology service agent or suitably qualifi ed person.

Make sure that the door is fully open before driving in or out of the garage and fully closed before leaving the driveway.

Make sure that remote controls are kept out of reach of children.

Install the (optional) wall switch or (optional) wall mounted transmitter in a location where the garage door is visible, but out of the reach of children at a height of at least 1.8 metres from the floor.