ATA GDO 4v4 Battery Backup Instructions

Installation Instructions for GDO-4 V4 BAttery
Back Up Kit (ALPS Only) Order Code: 01911

Important: Please follow instructions below for safe and easy installation.
– Follow steps 1 through 18 for sequence of installation.
– Numbers in brackets refer to items in Parts List.

1. Disconnect power to the opener and disengage motor.
2. Remove main cover from the opener.
3. Secure Lock Circuit Board Support (4) into the 4.8mm holes in the base (See Fig. 1).
4. Feed Wiring Harness (2) through the 30mm hole in the base (See Fig. 1).
5. Mount the Charger Board SBY-3 v1.00 (1) on base and swing in to lock with LC Board Support (4) (See Fig. 2).
6. Remove Light Diffuser.
7. Connect Wiring Harness (2) to Control Board socket (See Fig. 3).
8. Remove M4 x 12 screw securing Transformer wires. Secure Harness (3) using existing cable clamp and fasten screw (See Fig. 4).
9. Position the cable clamp (11) over harness (3) and secure with taptite screw “P” M3.5 x 8 (12) (See Fig. 4).
10. Mount the Batteries Assembly onto opener (located above the door axle) and secure with screws (10).