ATA GDO-6 & GDO-8 Installation Sheet

GDO-6 EasyRoller & GDO-8 Shed Master

Tools Required

• Ladder
• Adjustable Wrench
• Socket set
• Drill
• Screwdrivers
• Marker Pen
• Door Stand

Position
The opener can be installed on either the right – or left hand side of the door (when viewed from the inside the garage). The opener is factory set for right hand side installation. The opener must be installed in a dry position that is protected from the weather. Moisture or corrosion damage is not covered by the Warranty.

Unsuitable Door Types
The drive must not be used with a door incorporating a wicket door, unless the drive cannot be operated with the wicket door open The fitting of an opener to doors with removable mullions is not recommended.

Sideroom
The minimum sideroom required from the edge of the door curtain is 40mm to the inside of the door bracket, and 85mm to the wall. If a Battery Backup is to be fitted, at least 135mm to the bracket is required. Therefore the recommended sideroom from the edge of the door curtain is 135mm to the inside of the door brachet, and 175mm to the wall as per diagram.

Important Note:
Only TrioCodeTM 128 Technology Transmitters and Keypads are compatible with these GDO-6V4 and GDO 8V3 products.

Power Supply
Properly earthed 3 pin single -phase power is required.
WARNING! A portable power generator is not recommended due to spikes, surges and fluctuations in the supply.