ATA GDO 9v1

EASY ACCESS TRANSMITTER

The Easy Access Transmitter is prepared ready for use with the battery pre-installed. Before the transmitter can be operational, the transmitter code has to be stored into the openers memory. To store the code refer to Step 18.1 on page 19.

REMOVING THE COVER TO REPLACE BATTERY
1. Rotate the cover Clockwise to CLOSE
2. Rotate the cover Anti-clockwise to OPEN

REMOVING THE BATTERY
(Battery Type: 3V Lithium Battery CR1220). Use a non-metallic object (e.g pen) to remove the battery. Gently lever the battery out of the holder, taking care to not damage the circuit board. (Fig. 24)

WARNING
Metallic objects used to remove the battery may damage the circuit board or the battery.

REPLACING THE BATTERY
Make sure that positive (+) side is facing up. Place one side of the battery into the holder (Fig. 25), then press the battery in and down firmly until it clicks into a flat position.
Note: The length of the manual release cord is user adjustable. Simply slide the plastic toggle along the cord to achieve the desired length. Adjust the length of the cord so that it can be easily reached by an adult of average height (ie. less than 1.8m tall).