ATA – GDO2v6 Manual
Product Features
Your Securalift Automatic Garage Door Opener has many features which you will appreciate. The components and materials used in this Automatic Opener are of the latest technology and highest quality. Below are listed some of these features:
OPERATION To operate the door simply press the hand held transmitter or the wall mounted transmitter or optional wall switch for two seconds and the door will automatically open or close. The door can be stopped during an opening or closing cycle by pressing again. The next actuation will move the door in the opposite direction.
HOPPING CODE Every time a transmission is made from the Remote Transmitter a new security code is generated. The number of possible code combinations is over 4.29 billion. This greatly enhances security of the system. Code ’Grabbing’ is made a thing of the past.
ISS (INTELLIGENT SAFETY OBSTRUCTION SYSTEM) While the door is doing a closing cycle and if it should hit an obstacle or be restricted in some manner, it will automatically reverse. The amount of force the door should encounter before reversing, is automatically adjusted by the doors control system, during the initial installation of the automatic door opener. The door also if restricted whilst opening will stop. The Safety Obstruction Force should be checked at least once a month. See installation manual for instructions.
SECURITY CODE STORE The Opener uses state of the art technology in storing your selected Transmitter Security Code. Up to 27 different codes can be stored in the Openers memory. To store any code simply press and hold the Door Code button on the Opener and press the Transmitter button twice. Each or all codes can be deleted and changed at any time. The codes can also be stored from a remote location.
OVER LOAD INDICATOR When the maximum opening and closing capacity of the Opener is exceeded the Courtesy Light and Overload LED will flash to indicate that an Overload has occurred.
SERVICE INDICATOR The Opener has a Service indicator. When the Overload LED lights up continuously it means that the opener and, or garage door needs a service.
AUTO COURTESY LIGHT The Courtesy Light on the Opener comes on automatically whenever the door is activated to do an opening or closing cycle. The Light can also be switched on and off without operating the door. This is done by pressing the button on the Hand Held Transmitter or Wall Mounted Transmitter which has being stored as the light code, or by pressing the light button on the Wall Switch (optional). The light will stay on for approximately three minutes then go off.. This time is also adjustable.
CAS (COLOUR ASSISTED SETTINGS) To make the installation of the Automatic Opener more user friendly Automatic Technology Australia developed the CAS (Colour Assisted Settings) system. This unique system allows for all the Open and Close adjustments and settings to be colour coordinated, Red for Close and Green for Open. The colour coordination make its easier and quicker for the user or installer to complete the installation.
OPEN AND CLOSE DRIVE BUTTONS Another feature developed by Automatic Technology Australia in aiding in the installation of the opener are the Open and Close Buttons. These buttons are used to help set the open and close limit positions. A quicker setting time and a more precise limit position can be achieved using this system.
INITIALISATION The Reset button on the Door Opener is used to initialise or re-initialise the obstruction settings and door travel counts. See installation manual for instructions.
AUTO CLOSE MODE The Opener can be programmed to automatically close after an open cycle. The Auto Close time is adjustable. It is compulsory to install a Photo Electric Beam if this mode is selected, otherwise the door will not operate.
AUTO RUN TIME If the Motor is left running in the Opener for any reason the Auto Run Time will turn the motor off after thirty seconds.
PHOTO ELECTRIC BEAM (OPTIONAL) The Opener has an input for a Photo Electric Beam to be connected for extra safety protection.
MANUAL OPERATION The Opener is equipped with a unique Manual Disengaging Device. If the power to the Opener is disrupted for any reason the door can be put into Manual Mode by pulling down on the string handle on an angle towards the door, then releasing. This will allow you to manually open or close the door. To re-engage pull the string at an angle away from the door then release.
