ATA GDO2V6 Manual Update Jan04

STORING TRANSMITTER CODES

Make sure to connect the battery to the transmitters. The memory in the openers receiver can store up to 27 different remote control transmitters.

STORING TRANSMITTER CODE
1. Press and hold the Door Code button (Fig. 22).
2. Press the button (one of four) on the transmitter you would like to use to control the door for two seconds.
3. Pause for two seconds. Press the same button again on the transmitter for two seconds.
4. Release the Door Code button.
5. Press the transmitter button to test if it operates the door.

STORING TRANSMITTER(S) FROM A REMOTE LOCATION
Using this method you don’t need to have access to the control panel on the door opener. However, you do need a transmitter that is pre-coded to the opener’s receiver.

IMPORTANT NOTE: The door or courtesy light will be activated when the step below is performed. The door moving or light switching on is to confirm, from a remote location, that the correct button was pressed and the transmitter is in range of the opener.