ATA – GDO4V4 Instruction Manual

CODING TRANSMITTERS

SETTING TRANSMITTERS CODES Make sure to connect the battery to the transmitters. The memory in the opener receiver can store up to 23 different remote control transmitters.

STORING THE TRANSMITTERS CODE

  1. Press and hold the Door Code button (Fig. 20). 
  2. Press the button (one of four) on the transmitter you would like to use to control the door for two seconds, pause for two seconds. Press the same button again on the transmitter for two second. 
  3. Release the Door Code button. 
  4. Press the transmitter button to test if it operates the door. 

SETTING THE TRANSMITTER TO OPERATE THE COURTESY LIGHT

The transmitter can be programmed to operate the courtesy light on the door opener.

  1. Press and hold Light Code button (Fig. 21). 
  2. Press the button on the transmitter you would like to use to switch on the light for two seconds, pause for two seconds. Press the same button again on the transmitter for two seconds.
  3. Release all buttons to store the transmitter in memory.
  4. Press the transmitter button to test if it switches on the light.

SETTING THE TRANSMITTER TO OPERATE PET (PEDESTRIAN) MODE

  1. Press and hold Door Code button and the Close button (FIG. 21). 
  2. Press the button on the transmitter you would like to use to control pedestrian mode for two seconds, pause for two seconds. Press the same button again on the transmitter for two seconds.
  3. Release all buttons to store the transmitter in memory.
  4. Press the transmitter button to test if it operates the pedestrian mode.

To change the default pedestrian door opening position, refer to Item 15 on page 18.

SETTING THE TRANSMITTER TO OPERATE VACATION MODE

  1. Press and hold Light Code button and the Close button (Fig. 21).
  2. Press the button on the transmitter you would like to use to control vacation mode for two seconds, pause for two seconds. Press the same button again on the transmitter for two seconds.
  3. Release all buttons to store the transmitter in memory.
  4. To test, press and hold the transmitter button set for vacation mode for five seconds to set Vacation Mode.

To reset Vacation Mode press the same button for two seconds. Please note that when vacation mode is activated all stored transmitters will be locked out. This mode can only be deactivated by a transmitter which has been stored to activate this mode.

BACK TO GARAGE DOOR OPENER MANUALS LIST
DOWNLOAD PDF FILE
CLICK TO PURCHASE
M