B&D Pre 06 Easylifter manual

SETTING LIMITS

NOTE: If the door has not reached the desired limit position by more then 30mm, then it is recommended that the green limits cam be adjusted again before the green one adjustment screw is adjusted.

CLOSE LIMIT ADJUSTMENT
Press in and hold the red Close button . (Fig. 16). The door should start closing. Release the red Close button when the door reaches the desired closed position. If the red LED (Fig. 16) is illuminated and the desired limit position has been reached then the limit adjustment is complete. If the red LED is illuminated but you are not happy with the door close position, the red FineAdjustment Screw(Fig. 16) can be adjusted to one tune the close position. Adjust the screw anticlockwise to close the door less. To close the door more adjust the red Fine Adjustment Screw clockwise. Each complete revolution of the adjustment screw is equal to approximately 10 mm of door travel.

NOTE: If the door has not reached the desired limit position by more then 30mm, then it is recommended that the red limits can be adjusted again before the red one adjustment screw is turned.

SETTING LIMITS FOR LEFT HAND INSTALLATION

1. With the drive unit in manual mode (Fig. 17) move the door up by hand to the desired open position.
2. Remove the light diffuser (Fig. 17) . Rotate the green limit cam by hand in a clockwise direction (Fig. 18) until the cam clicks the open limit switch.
3. Move the door down by hand to the desired closed position.
4. Rotate the red limit cam by hand in an anticlockwise direction (Fig. 19) until the cam clicks the close limit switch.
5. Connect the power lead from the drive unit to a general purpose power outlet installed by a licensed qualified electrical contractor. Make sure that the power lead is safely fastened away from any moving parts. Turn the power on.
6. Re-engage the drive gear by pulling down on the string and then releasing it slowly (Fig. 17).