B&D TRV 300 Tiltamatic

IMPORTANT

• Do not attempt to install or service the opener with the power connected.
• Do not put hands or tools inside the power head with the power on. All adjustments and installation connections are made externally.
• Stay clear of the opener when it is in motion. Never operate the opener from a step ladder.

WORKING OPERATION OF DOOR
An automatic garage door opener cannot move a garage door that is in poor working condition. The door must operate freely with no binding or obstructions, and must be well balanced. Check the spring balance of the door by bringing the door to the half open position and leaving it there. If the door stays in that position, it is well balanced. The door should be far easier to close than it is to open, for the automatic door opener to work correctly.

Where possible, it is recommended that the door springs be adjusted, and the opener be installed by a qualified B&D dealer.

CAUTION

• The opener is 240 volts and must be installed in accordance with AS-3000 Standard Electrical Code.
• During installation the opener must be properly grounded with the power turned off.
• Use screwdrivers ONLY, to adjust limit switches. DO NOT USE a spanner or pliers.
• Power should be ‘OFF’ while the main cover is removed or replaced.
• The push button switch as supplied is for internal use only. If situated outside or near the door opening, this switch should be replaced by a weather resistant type, as defined in AS-3000.
• The door should be properly installed and adjusted, well maintained, and free of all obstructions.
• Install push button in a convenient position, but at least one metre from any door fittings, and out of the reach of children.
• Operate only when the door is fully visible. Do not allow children to play with the door controls.