ATA – NeoSlider manual v1.00

Important Safety Instructions

Please read this instruction manual fully before attempting to install or use the opener. Failure to comply with the installation instructions may result in serious injury and/or property damage.

The opener is showerproof – it should not be immersed in water or sprayed directly by a hose or other water carrying device.

The gate(s) must be well balanced. and in good working order. Faulty gates must be repaired by a qualified technician prior to opener installation.

Remove or disengage all gate locks and mechanisms prior to installation of the opener.

Connect the gate opener to a properly earthed general purpose 240V mains power outlet installed by a qualified electrical contractor.

Disconnect the power cord from mains power before making any repairs or removing covers. Only experienced service personnel should remove covers from the gate opener.

Keep hands and loose clothing clear of the gate and opener at all times.

When using Auto-Close mode, a Photo Electric Beam must be fitted correctly and tested for operation at regular intervals. Extreme caution is recommended when using Auto-Close mode. All safety instructions above must be followed.

In order for the gate opener to sense an object obstructing the gateway, some force must be exerted on the object. As a result the object, gate and/or person may suffer damage or injury.

Make sure that the gate is fully open before driving into or out of the driveway. And make sure the gate is fully closed before leaving the driveway.

The gate opener is not intended for use by young children or infirm persons without adequate supervision. Children should be supervised to ensure that they do not play with the remote transmitters or the opener.

Frequently examine the installation, in particular guides and mountings for signs of wear, damage or imbalance. DO NOT use if repair or adjustment is needed since a fault in the installation or an incorrectly balanced gate may cause injury.