ATA – SGO2V4-EasySlider Manual
PRODUCT DESCRIPTION
The ATA EASYSLIDER GATE OPENER consists of one electronic control box, two hand held transmitters antenna and a sliding gate drive unit (Fig 1).
CONTROL BOX
The control box contains the Control Board, (capable of driving 1 or 2 sliding gates), a remote control receiver and transformer. With a pre-wired antenna ready to mount. When used with suitable glands, it is designed to meet the IP56 weather proof rating.
DRIVE UNIT
The Drive Unit consists of a powerful 24V DC motor, rugged gear assembly and limit switch assembly, housed in a lockable enclosure. Each Drive Unit includes a final drive gear and limit switch actuators for both opening and closing limits.
INSTALLATION OF MECHANICAL DRIVE UNIT
The ATA EASYSLIDER GATE OPENER is designed to operate most domestic sliding gate(s) including solid gates. The gates must be in good working condition and should operate by hand relatively freely.
INITIAL CHECKING
Before commencing installation of the EasySlider Gate Opener, check the following:
- The gate will move freely by hand for it’s full opening and closing travel.
- The mounting must be solid construction (concrete brick, solid timber or steel). It must anchor most of the force applied by the drive unit.
- A weatherproof 240V 10A general purpose Power Point nearby.
- Select suitable location for mounting of the Drive Unit. This position is usually establish by opening the gate to its fully open position and mounting the Drive Unit within a suitable distance from the gate edge.
- If dual gate openers are required provision for underground cabling should be made from one side to the other.
